- Wiring Diagram
The FS-HDP4704 video balun hub is a passive (non-amplified) device that allows the transmission of real-time CCTV HD video signal via cost-effective Unshielded Twisted Paired (UTP) cable.The FS-HDP4704 is compatible with all HD-TVI, HD-CVI, AHD and CVBS analog cameras.
The FS-HDP4704 supports pluggable screw terminal or RJ45 connections. Used with single channel HD passive video transmitter, the FS-HDP4704 is capable to receive 4 channel live CCTV HD video signal from camera end via one UTP cable.
The superior interference rejection and low emissions of the FS-HDP4704 allow video signals to coexist in the same wire bundle as telephone, datacom, or low-voltage power circuits. This allows the use of a shared or existing cable plant. The FS-HDP4704 is built-in surge suppressor to protect video equipment against damaging voltage spikes and provide noise immunity to ensure quality signals without disturbing "hum-bars".
• Security Monitoring System
• Multimedia Network Teaching System
• Medical Monitoring Display System
• Industrial Automation Control System
• Banking, securities, financial information display system
• Remote Network Server Monitoring
• Department Store Security
• Casino Security
• Hospitals, Airports and banks
• School Campuses
1. The actual transmission distance will vary according to specific camera, DVR and on-site environment
2. Please make sure to install transmitter at camera side and receiver at DVR side to achieve best video quality
3. If you adjust saturation of DVR, video transmission distance could be farther.(HD-CVI 720P: max up to 470m(1541ft)
4. If chromatic aberration occurs, please also adjust saturation, the picture will recover perfectly automatically.
5. The device is not waterproof and not to be used at outdoors.
Wire and Cable Recommendations
The FS-HDP4704 is recommended to use with Unshielded Twisted Paired (UTP) wiring from 24AWG through 22AWG.Individually shielded pairs should be avoided, as they reduce the operating range of the systems drastically. Multi-pair cable (25-pair or more) with an overall shield are acceptable. Video signals can coexist in the same wire bundle as telephone, datacom, or low-voltages power circuits. While video may be routed through telephone punch-down block terminals, any bridge-taps, also called T-taps and any resistive, capacitive or inductive devices MUST BE removed from the pair.